Winegard HD-1080 Manuel d'utilisateur télécharger pdf

Reector

Elements

Front Boom

Reector

(Hex Nuts)

Downlead Connection

WINEGARD

Model HD-1080 DTV Antenna

WARNING

READ THE ACCOMPANYING SAFETY INSTRUCTION SHEET BEFORE PROCEEDING WITH ANTENNA AND/OR MAST

ASSEMBLY AND INSTALLATION. INSTALLATION OF THIS ANTENNA NEAR POWER LINES IS DANGEROUS. FOR YOUR

SAFETY, FOLLOW THE INSTALLATION INSTRUCTIONS.

Printed in U.S.A. © Winegard Company 2009 • Winegard Company • 3000 Kirkwood Street • Burlington, IA 52601-2000 Rev7 12-13 1450510

90 DAY LIMITED WARRANTY

Step 1. Remove antenna from carton. Unfold elements and reectors. Make sure that they are straight and perpendicular to

the boom.

Step 2. Attach mast clamp to the back boom (larger antenna section) antenna using the screw and hex nut supplied, Fig. 2.

Step 3. Using the bolts and hex nuts provided, attach the smaller section to the larger section of the antenna using the

spacers as shown in Figure 1.

Step 4. Mount antenna on top of mast and lightly tighten mast clamps.

Step 5. On the back of the smaller section, line up the two phasing lines and insert the smaller screws from the hardware bag

so that the head of each screw faces the larger section of the antenna. Place two washers on each screw and install

the nut to hold the washers in place DO NOT TIGHTEN. Connect matching transformer to the downlead connection.

Slide spade lugs of matching transformer between the washers. Tighten hex nuts securely. With the screws in place,

connect the coax downlead to the matching transformer on the antenna, but do not secure at this time. Then

connect the coaxial cable to your TV.

Step 6. Point front of antenna towards stations and tighten mast clamp securely, Figure 1.

Step 7. Secure coaxial downlead to the mast using tape to prevent whipping by the wind.

Step 8. Ground antenna and mast per accompanying Safety Instruction sheet.

*Grounding the antenna is not required for indoor installations.

WINEGARD

FRONT

Reector

Element

Matching

Transformer

(must face TV station)

Phasing Lines

Spacers

Mast (2" OD Max.)

*not included

Attach

antennas

together with

bolts and hex

nuts installed

in larger

section.

FIGURE 1

Mast

Clamp

U-Bolt

Repeat both steps indicated on other end of boom.

Spacer

Bolt

Hex Nut

Mast Clamp

Back

Boom

FIGURE 2

Nut

Bolt

winegard.com/myantenna

WINEGARD 1

Résumé du contenu

Page 1 - WINEGARD

Reector ElementsFront BoomReector(Hex Nuts)Downlead ConnectionWINEGARD®Model HD-1080 DTV AntennaWARNINGREAD THE ACCOMPANYING SAFETY INSTRUCTION SHEE

Commentaires sur ces manuels

Pas de commentaire

Winegard HD-1080 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Antennes de réseau Winegard HD-1080. Winegard HD-1080 User's Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Antennes de réseau Winegard HD-1080