Winegard SF-1000 Manuel d'utilisateur télécharger pdf

Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000

Printed in U.S.A. © Winegard Company 2003

www.winegard.com 2430651 Rev. 2-03

MODEL SF-1000

5-5/8"

3-5/8"

card size 5-5/8" x 3-5/8"

Made In USA

SATELLITE

FINDER METER

S:\PACKAGE\RV-6022

1. Disconnect the coax from the LNBF and connect it to the

“To RCVR” jack on the SF-1000.

2. Plug in receiver and turn power on.

3. Set receiver to the signal strength screen.

Note: See your Operators manual for your brand of receiver.

4. Enter the local zip code in the appropriate area and note the

azimuth and elevation angles that are displayed.

5. Adjust the knob on the SF-1000 so the meter indicates

between 3 and 4.

6. Connect one end of the supplied jumper coax to the “FROM

LNBF” jack on the SF-1000 and the other end to the LNBF.

7. Adjust the antenna to the azimuth and elevation angles that

were determined in Step 4.

8. Very slowly adjust the dish up and down and left and right

until the meter reaches 10 on the scale.

9. Observe the signal strength meter of the receiver on the TV

screen to verify that the right satellite has been located.

10. If the right satellite was NOT located, readjust coarse

settings.

11. If the right satellite was located, set the adjustment knob on

the SF-1000 back to 5 and continue peaking the dish.

12. As you reach 10 each time you peak the dish, move the

adjustment knob back to 5 and continue until you can no

longer improve the signal strength.

13. Unplug the receiver from its power source.

14. Without disturbing dish position, disconnect coax from LNBF.

15. Disconnect coax from the “TO RECEIVER” jack on the

SF-1000 and connect this coax to the LNBF.

16. Restore power to the receiver.

NOTE: DO NOT adjust the “SENS ADJUST” on the back of the

SF-1000.

Specifications

Frequency Range .................. 950-2050 MHz

Impedance ............................. 75 ohm

Input Level ............................. -25 to -75 dBm

Power Required .................... + 13 - +18 VDC

(Provided by receiver)

SF-1000

RECEIVER

Meter with audio tone helps you

align satellite antenna to

satellite signal.

Meter connects between satellite dish/LNBF

and satellite receiver. With the Winegard satellite

finder meter you can easily tune the satellite dish

to your favorite satellite while outside at the

antenna without having to run inside to view the

set-up menu on the receiver.

SF-1000

RECEIVER

SATELLITE 1
FINDER METER 1

Résumé du contenu

Page 1 - FINDER METER

Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000Printed in U.S.A. © Winegard Company 2003www.winegard.com 2430651 Rev. 2-03MODEL SF-1

Commentaires sur ces manuels

Pas de commentaire

Winegard SF-1000 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Antennes satellites Winegard SF-1000. Winegard SF-1000 User's Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Antennes satellites Winegard SF-1000