Winegard RT8035S Manuel d'utilisateur Page 2

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 1
2
Parts Included • Tools Needed • Unpacking the Unit
1 Dome
1 base with electronics, dish, dual LNBF
*Aftermarket versions also include all mounting hardware and cabling required for a
single receiver installation
PARTS INCLUDED*:
USE 2 PEOPLE
when removing the unit
from the carton.
!
DO NOT PAINT DOME!
Painting dome will cause
signal degradation and
will void your warranty.
TOOLS NEEDED FOR UNPACKING & INSTALLATION:
Level
Drill with 3/4” bit
1-1/4” hole saw (if mounting switch in wall)
Phillips screw driver #2
3/8” Open end wrench
7/16” Open end wrench
Sealant (consult RV manufacturer for proper type
for your roof material)
Trademarks:
Winegard and RoadTrip Minimax are registered trademarks of Winegard Company. DISH Network is a registered
trademark of EchoStar Communications Corp. DIRECTV is a registered trademark of Hughes Electronics Corp.
All trademarks contained in this manual are property of their respective owners. Reference made to products or
services provided by companies, other than Winegard Company, does not represent any endorsement of those
products or services.
Disclaimer:
Although every effort has been made to insure the information in this manual is correct and complete, no company
shall be held liable for any errors or omissions in this manual. Changes and technological advances are continu-
ously being made in the satellite market. Information provided in this manual was accurate at the time of printing.
If the RoadTrip Minimax does not function as expected, please contact Winegard Company at (800) 788-4417 or
visit our website at www.winegard.com.
For Winegard Warranty Information:
Attn: Technical Services
Winegard Company
3111 Kirkwood St.
Burlington, IA 52601
800-788-4417
Fax: 319-758-5854
1. Open box and remove packing material.
!
If using knife to open
carton, BE CAREFUL.
Do not cut the dome on
the unit.
UNPACKING THE UNIT:
2. Lift unit out of box vertically. Do not turn box
and “roll” out, or turn upside down to remove.
Vue de la page 1
1 2 3 4 5 6 7 ... 11 12

Commentaires sur ces manuels

Pas de commentaire