Winegard SK-3005 Manuel d'installation télécharger pdf (Page 4)

NOTE: Anything in the striped area will interfere with the operation of the TRAV’LER antenna

and may cause damage to the object or the TRAV’LER antenna.

TRAV’LER Mount Installation

Verify that the “FRONT” of the transition plate is facing the front of the vehicle, then place the

TRAV’LER antenna mount on the roof where you plan to install it. See Figure 3. Mark where the screw

holes will go by placing marks through the holes in the mount base on the roof of the RV. It is impor-

tant that you be able to see these marks! Move the TRAV’LER mount out of the installation area. It is

recommended that you don’t pre-drill the holes at this time.

Use a solid bead of sealant to connect these marks in the shape of the base.

Replace the TRAV’LER antenna base and screw it to the roof. Check with your vehicle manufacturer for

any special screw requirements before using the supplied screws.

3. The unit must be within 3° of level for best operation.

4. Make sure that the location offers enough support to attach the TRAV’LER antenna securely.

5. Find a well ventilated location with a 110 V outlet for the TRAV’LER Interface inside the vehicle.

Make sure to clean the installation area before you begin.

You will want to decide where the wires will enter the vehicle. One coax cable per receiver and a control

cable will need to be run into the vehicle.

Warning: Do not run the wires through the striped area shown. Consult your receiver

manual for specics in the diagram.

FIGURE 3

INSTALLATION

FRONT OF RV

TRANSITION

PLATE

FRONT

SCREW

HOLES

24 inches

18 inches

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Winegard SK-3005 Manuel d'installation Page 4