Winegard SK-7003 Mount Spécifications télécharger pdf (Page 4)

OPERATION

TROUBLESHOOTING:

ANTENNA CONNECTION FAILED

EL HOME FAILURE

AZ MOTOR STALLED

EL MOTOR STALLED

SK MOTOR STALLED

STOW FAILURE

ANT NOT STOWED

STOW FAILURE

STOW UNKNOWN

AZ MOTOR RUN REVERSE

EL MOTOR RUN REVERSE

SK MOTOR RUN REVERSE

AZ MOTOR RUNAWAY

EL MOTOR RUNAWAY

SK MOTOR RUNAWAY

NO LNB VOLTAGE

UNKNOWN ERROR ######

C MOTOR NOT FOUND

ANTENNA WILL NOT AUTOMATICALLY STOW

UNSUPPORTED ODU HARDWARE

UNSUPPORTED ODU SOFTWARE

GPS FAILURE

Check the data cable connection on the back of the Trav’ler Interface.

It may not be connected properly.

Something is preventing the TRAV’LER Mount from raising as it at-

tempted to nd the HOME position. Look for obstructions if unit has

recently been manually raised, or the electronics have been replaced.

The calibration may need to be reset. Contact Winegard Technical

Support 1-(800) 788-4417.

Something is preventing the TRAV’LER mount from rotating; look for

obstructions. If no obvious obstruction, contact Winegard Technical

Support 1-(800) 788-4417.

Something is preventing the TRAV’LER mount from raising or lower-

ing; look for obstructions. If no obvious obstruction, contact Winegard

Technical Support 1-(800) 788-4417.

Something is preventing the TRAV’LER reector and LNBF from rotat-

ing; look for obstructions. If no obvious obstruction, contact Winegard

Technical Support 1-(800) 788-4417.

The TRAV’LER is not stowed. Do not try to move the vehicle. Try to

stow the TRAV’LER again. If it fails again, check for obstructions.

Check the data cable connection on the back of the TRAV’LER Inter-

face. It may not be connected properly.

Contact Winegard Technical Support 1-(800) 788-4417.

The TRAV’LER is not seeing the required 13-18VDC needed to power

the LNBF. Check the coax connections. If these are all connected

properly, contact Winegard Technical Support 1-(800) 788-4417.

Contact Winegard Technical Support 1-(800) 788-4417.

See Emergency Manual Stow instructions. See Page 9 of Installation.

Contact Winegard Technical Support 1-(800) 788-4417.

The GPS has taken longer than 10 min. to acquire. Contact Winegard

Technical Support 1-(800) 788-4417 if this happens frequently.

Note: Weather and vehicle location can impact the ability of the TRAV’LER antenna to locate all of the required satellites.

Obstructions such as buildings or tree limbs can block the satellite signals and prevent the TRAV’LER antenna from successfully

locating all of the satellites for Multi-Sat Mode. Make sure you have a clear view of the Southern sky.

POSSIBLE SOLUTION:

ERROR CODE:

OPERATION

Hooking up the Shaw Direct receiver

Connect your Shaw Direct receiver to the TV using the appropriate audio and video cables. (Refer to

your television user manual for the best audio /video connections).

If you have not chosen a programming package for your Shaw Direct system or added this receiver to

your existing Shaw Direct account, please call 1-888-554-7827 prior to using your Shaw Direct receiver

for the rst time.

Ensure that your Shaw Direct receiver is connected to power.

Locate the coaxial feed coming from TRAV’LER system.

Connect the satellite feed to the coaxial input labeled with the symbol of a satellite dish.

Power on the Shaw Direct receiver and television.

If your TRAV’LER system is properly tuned and receiving signal, the satellite dish icon on the front of

the Shaw Direct receiver will be highlighted in green.

If the TRAV’LER system is stowed or not tuned to the Shaw Direct satellites, the satellite icon on the

front of the Shaw Direct receiver will appear in red. Turn on the TRAV’LER unit or troubleshoot as

needed to reachieve positive signal.

If your Shaw Direct system is disconnected from power for an extended period of time or you has been

recently moved from another location, you may need to have your Shaw Direct system reauthorized.

This can be determined when you receive a green (positive) signal, but can not receive video on a sub-

scribed channel.

To initiate a signal refresh call 1-888-554-7827, then select “Self-Serve”, “Technical Support”, followed

by “Signal Refresh” from the telephone menu options.

For changes to Shaw Direct programming or to purchase new Shaw Direct equipment visit

shawdirect.ca or call 1-888-554-7827.

NOTE: The TRAV’LER antenna will nd the satellites without the receiver installed.

NOTE: If the TRAV’LER antenna is connected to multiple receivers and any one is locked on the satellite, all receivers should

be locked on signal. If one or more are not, check the coax connections for 13-18VDC at the LNBF. Without this voltage, the

receiver will not get a signal.

Rev. 4/09

1 2 3 4 5

Commentaires sur ces manuels

Pas de commentaire

Winegard SK-7003 Mount Spécifications Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Antennes de télévision Winegard SK-7003 Mount