Winegard RoadTrip Mission Manuel d'installation Page 5

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 8
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 4
5
Installation
Install in DRY conditions only!
Installing unit on roof of vehicle —
FIGURE 3
OBSTRUCTION
UNIT BASE
4. After selecting location for unit (see number 2), put the unit
on the centerline of the vehicle.
5. Position base so that cables exit either toward the rear
(Mounting Option A) or toward the front (Mounting Option B In-
Motion mounting option only) of vehicle. See page 4.
Control Unit box MUST be parallel to the center line of the ve-
hicle. See page 3.
7. Clean roof area where the base feet will be attached to
the roof. Do not erase your marks!
8. Put approved sealant in the areas marked for the base
feet. Place base feet on top of the sealant and screw
down with the (3) #10 screws for each foot.
9. After all base feet are secured to roof, put sealant
around edge of feet and over screws.
FIGURE 5, Mounting Option A shown
6. Place the unit on the roof in its permanent location and mark
around each base foot, Figure 4.
FIGURE 4
A B’
ROADTRIP
Front of Vehicle
Center Line
The distance from the edge of the roof to the rear corner
of the foot should be equal on both sides of the dish to
ensure proper installation.
Obstruction Ht. Unit Clearance
8” .................................................2”
10” ...............................................8”
12” .............................................13”
15” .............................................22”
REV. 5/06
IMPORTANT! Do not install this system in the rain, or under
any wet conditions. Moisture may affect electronics and void
your warranty!
1. For best performance and to reduce signal acquisition
time, park vehicle on a level surface; level the RV.
2. Select a level spot on your roof for installation.
WARNING: Level the base front to back and side to side. If
base is not level the antenna may require more time to locate
the correct satellite or may not locate the correct satellite.
•Besurenoroof-mountedequipmentis
blocking the satellite “line of sight”, Fig. 3.
3. Ensure proper distance to other rooftop equipment is
maintained.
Using this chart,
determine the minimum distances
to other equipment.
!
Vue de la page 4
1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire