Winegard RT8035S Manuel d'utilisateur Page 3

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 2
3
DISH NETWORK HYBRID
1 2 3 4 5 6 7 8
0 = UP
1 = DOWN
KEY
BELL TV
1 2 3 4 5 6 7 8
FIGURE 1
4. After selecting location for unit (see Step 2), place
the unit on the centerline of the vehicle.
5. Position base so that cables exit toward the rear of
vehicle.
The distance from the edge of the roof to the rear cor-
ner of any foot should be at least 12” on both sides of
the dish to ensure proper installation.
Hybrid Mode settings are for use in areas where the
standard DISH Network settings fail to provide HD
programming.
Quick Reference Guide
This model is PRESET for DIRECTV receivers.
If you have a DISH Network or BELL TV receiver, you must change
the numbered switches (see gures below).
!
Install in DRY conditions only!
Installing unit on roof of vehicle —
Obstruction Ht. Unit Clearance
8” .....................................15”
10” ...................................20”
12” ...................................25”
15” ...................................35”
IMPORTANT! Do not install this system in the rain, or
under any wet conditions. Moisture may affect electron-
ics and void your warranty!
1. For best performance and to reduce signal acquisi-
tion time, park vehicle on a level surface; level the RV.
2. Select a level spot on your roof for installation.
WARNING: Level the base front to back and side to
side. If base is not level the antenna may require more
time to locate the correct satellite or may not locate the
correct satellite.
3. Ensure proper distance to other rooftop equipment is
maintained.
Be sure no roof-mounted equipment is blocking the
satellite “line of sight”; see chart below.
Using this chart, determine the minimum distances to
other equipment.
At least 12”
At least 12”
RoadTrip Minimax
MUST Face FRONT
of Vehicle
FIGURE 2
FRONT OF VEHICLE
Cable connections
MUST face REAR
OBSTRUCTION
UNIT BASE
2
3
4
5
TO CHANGE SWITCH SETTINGS FOR DISH
NETWORK. SIMPLY MOVE #4 & #7 TO DOWN
POSITION (#8 SHOULD REMAIN DOWN ALSO).
1 2 3 4 5 6 7 8
DIRECTV DISH NETWORK
FACTORY PRESET
DIRECTV SWITCH SETTINGS
1 2 3 4 5 6 7 8
Vue de la page 2
1 2 3 4 5 6 7 8 ... 11 12

Commentaires sur ces manuels

Pas de commentaire