Winegard RT8035S Manuel d'utilisateur télécharger pdf (Page 4)

7. Clean roof area where the base feet will be

attached to the roof. Do not erase your marks!

8. Put approved sealant in the areas marked

for the base feet. Place base feet on top of the

sealant and screw down with the (3) #10 screws

for each foot.

9. After all base feet are secured to roof, put

sealant around edge of feet and over screws.

6. Place the unit on the roof in its permanent loca-

tion and mark around each base foot, Figure 3.

FIGURE 3

Cable entry installation —

1. Connect the quick disconnect power cable to the

panel mount on the back of the RoadTrip Minimax

unit. See Figures 4 & 5 below.

POWER PLUG

LOCK

MAIN Port

SECONDARY Port

QUICK DISCONNECT SOCKET

LOCK (ON TOP OF THE CONNECTOR)

FIGURE 4

FIGURE 5

NICKS OR CUTS IN WIRING JACKET MAY

CAUSE WATER TO LEAK INTO VEHICLE.

CABLE-

ENTRY

CABLE CLAMPS

COAX CABLE ROUTING

PRIMARY

RECEIVER

ROADTRIP

MINIMAX

SECONDARY

RECEIVER

FIGURE 6

Decide the best location for the power and coax

cables to enter the vehicle, and the location of the

power switch and receiver. Drill a 3/4” hole in the

roof, push wires inside.

2. Connect the Primary receiver to the Primary

Port on the panel mount.

3. For a two receiver installation, connect

a second coax cable (not provided) to the

SECONDARY connector on base and run cable

along roof to second receiver location.

4. Place cable-entry plate over hole and cables.

Screw in place. Seal plate and screw holes with

approved sealant (not included).

5. Depending on the length of the cable on the

roof, you may need to use cable clamps or wire

ties (not provided) between the unit and your

cable-entry plate. Clamping the cable every 12”-

16” should eliminate any unnecessary cable

movement, Figure 6.

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire

Winegard RT8035S Manuel d'utilisateur Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Antennes satellites Winegard RT8035S