Winegard SK-3005 Manuel d'installation télécharger pdf (Page 5)

Run a solid bead of sealant around the transition plate, making sure to cover each screw head. Be

careful not to get any sealant above the lip of the transition plate. See diagram of transition plate.

Cable Entry Plate Installation:

Decide the best location for the cables to enter the vehicle.

You will need to run:

A coax directly to each receiver location.

A control cable to the TRAV’LER Interface box.

Drill a 1/2” hole in the roof and push the required wires through. (Installations for multiple receivers may

require a larger hole or multiple holes as each receiver requires a dedicated coax cable.) Each receiver

will require at least one coax cable. See receiver manual for wiring details.

Place the cable entry plate supplied in hardware bag over the hole and cables. Screw the plate in place

and seal the plate and screw holes with approved sealant (not included).

Depending on the length of the cable on the roof, you may need to use cable clamps between the unit

and your cable entry plate. Clamping every 12-16” should eliminate any unnecessary cable movement.

FIGURE 4

LIP OF

TRANSITION

PLATE

DO NOT SEAL

SEAL

FIGURE 5

OVERALL INSTALLATION DRAWING

WARNING: DO NOT cut any

wires when you drill the hole

for your cables.

FRONT OF RV

POWER

SUPPLY

For best results, use TV

1 for the receiver that will

be most active.

ENTRY PLATE

Winegard recommends in-

stalling the Accessory Detect

Cable, this can provide a

emergency stow function.

The SK-3005 will support up to

four receivers. It can support

more receivers with a DIRECTV

multi-switch.

Rev. 4/15/08

TV 1

TV 2

TV 3

IDU

INSTALLATION

RECEIVER

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire

Winegard SK-3005 Manuel d'installation Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Antennes de télévision Winegard SK-3005