Winegard MV3500A Spécifications Page 10

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 39
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 9
8
After power/data cable and coax cable(s) have been routed to Satellite Interface, seal under-
neath cable entry plate with approved sealant and screw down plate using 12 screws with
drill and 5/16” nut driver. Seal over screw heads and around entry plate. Clamp excess
cable with supplied cable clamps and screws. Seal around screw holes.
3.3 Plug Power Cable into Satellite Interface
If the original power cable was removed from the satellite antenna in the previous step,
disconnect the power wire from the power switch inside the RV. Discard switch, wall plate,
and original power cable.
Connect power/data cable power wires to green connector provided in hardware bag.
Screw top screws down to secure cables. See Figure 3.4.
Plug green connector into back of Satellite Interface Box in port labelled “DC OUT TO
SAT ANTENNA BLK/RED.” Screw in side screws to secure to box. See Figure 3.5.
Do not cut the
power/data cable. You
should coil excess cable in-
side or behind the cabinet.
Figure 3.5
Figure 3.4
Red Wire
Black Wire
At this point, if your Satellite System does not need a software update, or has
already been updated, you may plug the data cable inside of dome into the modular con-
nection on the electronics board. Verify that all connections have been made and all cables
have been tied to base using cable ties. Replace dome using 8 screws. Be sure dome
screws are securely fastened. See Figure 3.3.
Figure 3.3
Note: Movin’ View board shown. RoadTrip board will be slightly
different
You may replace
your old wall plate with a
standard size blank plate
available at any hardware
store.
SAT.
ANTENNA
IN
SAT.
RECEIVER
OUT
FACTORY
USE
ONLY
HD
CTRL 1
HD
CTRL 2
COMM. OUT 1
TO SAT.
ANTENNA
DC IN
DC OUT
TO SAT
ANTENNA
BLK/RED
SAT.
ANTENNA
IN
SAT.
RECEIVER
OUT
FACTORY
USE
ONLY
HD
CTRL 1
HD
CTRL 2
COMM. OUT 1
TO SAT.
ANTENNA
DC IN
DC OUT
TO SAT
ANTENNA
BLK/RED
Vue de la page 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 38 39

Commentaires sur ces manuels

Pas de commentaire