Winegard MV3500A Spécifications télécharger pdf (Page 9)

If you are installing the HD Satellite Interface as an add-on to a previously installed

Winegard Satellite Antenna, you should install the software update to your satellite antenna

rst, then proceed with cable and HD Satellite Interface installation. Refer to 3.7 Install

Software Update with Clone Box for instructions.

3.2 Route Cables (If Necessary)

If your Winegard Satellite System on your roof came installed with the power/data cable,

or if your coach was pre-wired for a Winegard Satellite System and HD Interface, you may

proceed to the next step. If your system was wired using only the red/black power wire,

you must route the new 30’ power/data cable included.

If you are replacing the current power wire, remove the sealant and 8 screws from the roof

top cable entry plate using the drill and 5/16” nut driver bit and discard. If not already

done, remove the dome from the antenna by removing the eight dome screws with a Phil-

lips head screwdriver. Do not lose dome screws!

Trace the current power wire to the Heyco Connector going into base. Remove the large

nut, Heyco Connector, and small nut inside base using the 3/4” wrench or crescent wrench

and discard. See Figure 3.1.

Locate the green connector that connects the power wire to the electronics board. Using a

small at head screwdriver, unscrew the 2 side screws and disconnect from board.

Unscrew top two screws and remove connector from cable. Do not lose green connector!

Cut wire ties and pull power cable out of dome.

Locate end of new power/data cable with LONGER exposed data cable. Route this end

of the power/data cable through power wire hole. With top screws facing up, insert power

wire into saved green connector and screw down top screws to secure. See Figure 3.2.

Plug green connector into power connector on electronics board. Screw in 2 side screws

to fasten. Do not connect data cable yet if software update must be done. Pull slack out

of cable from outside base, and push new Heyco connector into base. Pull on Heyco to be

sure it is secure. Fasten cable to base cleats or wire tie holders using wire ties.

Route power/data cable through existing roof hole and into Interface/Receiver location.

You may want to attach new cable to old power cable using electrical tape to help pull wire

through. If not already done from a previous installation, route primary coax into hole to

receiver as well. If necessary, route second coax to location.

Be sure to verify your

previously installed antenna’s

wiring. You may be able to

save installation time if it

already includes the data

cable.

Figure 3.1

One end of the power/

data cable has a longer data

cable. Use the longer end

inside of the dome and short

end inside of the RV.

Be sure loose cables

inside of dome will not inter-

fere with dish LNB.

Large Nut

Heyco Connector

Small Nut

Figure 3.2

Red Wire

Black Wire

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 38 39

Commentaires sur ces manuels

Pas de commentaire

Winegard MV3500A Spécifications Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Antennes de télévision Winegard MV3500A