Winegard MV3500A Spécifications télécharger pdf (Page 28)

To reset the Satellite Receiver, press and hold the Power button on the Receiver (not on the

remote control). The receiver will reset, and after a few moments will automatically restart.

It may take up to 5 minutes for some receivers to restart.

After the receiver reboots, the new Guide will download, and the programming on the new

satellite will be available. You must repeat this process each time you manually change

satellites for Dish Network or Bell ExpressVU.

Returning to Automatic Mode

The antenna will remain in Manual Mode until a Service Provider is chosen to put the

antenna back into Automatic Mode. See the operating section for your service provider for

instructions on choosing your service provider.

To Operate in Manual Mode

From the Main Menu, press [ENTER] to conrm Satellite Setup.

Press [SELECT] to select Manual Mode.

Press [ENTER] to conrm.

Press [SELECT] to cycle through the available satellites.

When you have selected your desired satellite, press [ENTER]. A Conrmation screen will

appear, and you will be prompted to Save Changes.

Press [SELECT] to select YES.

Press [ENTER] to conrm.

The Satellite Interface will reset, and the satellite antenna will begin its search routine for

the selected satellite. After acquisition, you will be able to watch television on the selected

satellite.

Satellite Interface

POWER

SELECT

ENTER

Manual Mode*

Factory Default

Satellite Interface

POWER

SELECT

ENTER

Satellite Setup*

Sleep Menu

Satellite Interface

POWER

SELECT

ENTER

Sat: 61.5

72.5

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 38 39

Pas de commentaire

Winegard MV3500A Spécifications Page 28